Table of Contents
Advertisement
Figure 5. The Found New Hardware Wizard's Browse Screen
4. When Windows prompts you whether to continue the installation or stop, click the
Continue Anyway
prompt you more than once). When the installation is complete, click
FTDI USB-to-UART Driver Installation
An FTDI USB-to-UART driver is required to allow your PC to communicate through its
USB port to the on-chip UART of the Z51F0811 MCU. Observe the following procedure to
perform these connections.
1. Ensure that the USB cable is not plugged in to the Z51F0811 Evaluation Board's P1
connector.
2. Navigate to the following filepath and double-click the
begin the driver installation.
<Z8051 Installation>\Z8051_<version>\device drivers\FTDI Uart
UM024201-0212
button and wait until the installation is completed (Windows may
Install the Z8051 OCD Software and Documentation
Z51F0811 MCU Evaluation Kit
User Manual
.
Finish
CDM20802_setup.exe
7
file to
Advertisement
Table of Contents
