Avery Dennison MONARCH 939I Operating Instructions Manual page 20

Decide if you want to see this prompt in Batch Entry mode and press
3.
either or
Decide if you want to change the default (1) for the quantity of tags to
4.
print in a batch. Enter a quantity (1-32000).
Press N.
After setting the batch options, you are ready to use Batch Entry mode to
enter data for your formats. See Chapter 3, "Entering Batch Data," for more
information.
Keep in mind the following definitions:
Number of Parts
Cut Multiple
Note: The cut multiple does NOT effect the printed quantity.
2-6 Setting Batch Options
to display your selection. Press N.
Quantity
1 _ _ _ _ _ _ _ _
Number of times data prints across the tag's width.
Using one to print data once on the tag. Using three to
print data three times across the tag.
Number of tags printed between cuts as a set. A cut
multiple of one cuts after each tag. To cut after each
batch, set the cut multiple equal to the print quantity.
If the cut multiple is three and the print quantity is 15,
five sets of three tags are printed and cut (15 tags). If
the cut multiple is three and the print quantity is 16, five
sets of three tags and one set of one tag are printed and
cut (16 tags).