Cleaning Procedure - Kärcher BRC 46/38 C Operating Instructions Manual

1in.
(25mm)
VACUUM
INTAKE COVER
1ft.
(30cm)
OFF
SOLUTION
INTAKE COVER
BRC 46/38 C 86306850 12/27/07

CLEANING PROCEDURE

STEP Start at wall closest to power outlet. Pull
1 straight back without pushing down on
handle.
STEP Release intermittent setting or turn off
2 continuous setting on brush/spray switch
approximately 1 foot before ending
cleaning pass.
STEP Push down on handle to raise vacuum
3 shoe and brush before moving to the next
cleaning pass. Overlap brush contact
area approximately 1inch.
During operation, observe the following: The
FB10 is equipped with clear internal covers to
STEP
facilitate operator viewing of dirty solution and
4
vacuum air flow.
During operation, observe the vacuum intake
cover. Large amounts of water or foam entering
the vacuum system can damage the vacuum
motor. If you notice either condition, shut down
the machine immediately. Empty recovery
tank and/or add defoamer to recovery tank.
3-8