Table of Contents
Advertisement
Appendix E:
Joystick/Rotary Interface
Joystick:
The KE-USB108 features four 3 position interface connectors
which accept axis X, Y, Z and Rx signals from a potentiometer.
The Rx axis is labeled W on the KE-USB108.
Power is supplied to the potentiometer from the KE-USB108 for 5
volt operation only. This interface is compatible with most popular
potentiometer based joysticks.
Use our MTA100-3-12 cable to help
connect from the KE-USB108 to a
joystick potentiometer.
Use the diagram to the right to make
a connecting cable for a joystick
potentiometer.
The potentiometer resistance must be between 10K ohms and
1M ohms.
NOTE: Do not supply any power into the Joystick interface connectors.
29
Gnd for Rx axis
Rx Input
5V = Power for Rx axis
(Rx labeled W on board)
Gnd for Z axis
Z Input
5V = Power for Z axis
Gnd for Y axis
Y Input
5V = Power for Y axis
Gnd for X axis
X Input
5V = Power for X axis
Advertisement
Table of Contents
