Table of Contents
Advertisement
Spinner Jumper Settings:
* Pull-Ups - Spinners that require outputs to be pulled up to +5V
may be accommodated by placing the jumper on to the center pin
and the pin at the bottom of the header (active low).
* Pull-downs - Spinners that require outputs to be pulled down to
logic ground may be accommodated by placing the jumper on to
the center pin and the pin at the top of the header (active high).
Joystick Axes
The section labeled "Joystick Axes" is
used to configure the potentiometer
inputs for each joystick axis. By
default, all of the axes are disabled
(see the picture to the right).
Each axis can be individually enabled as needed by checking the
"Enabled Joystick Axis" boxes.
Important: Only select a particular joystick axis if that axis has a
potentiometer connected to the corresponding KE-USB108 joystick
header.
File Menu Selections
The file menu selections,
located within a dropdown
list, as shown to the left, are
accessed by clicking on "File"
in the upper left corner of the
main program screen. This
list provides several options
that include creating and
saving file configurations as
well as reading and writing
to the KE-USB108.
20
Advertisement
Table of Contents
