Terex PT100 Operation And Maintenance Manual page 71

7 MAINTENANCE
7.10 Water Separator
The water separator (fig. 7.10-1),
located on the left side of the engine)
removes water from the fuel supply
as the engine runs. Drain the water
separator daily to maintain proper
function.
To drain the water separator:
1. With the engine off and cool,
and key removed from the ignition, open the hood at the rear of the
machine to access the water separator.
2. Twist valve on the bottom of the separator counter cloclwise to drain any
water from the catch bowl.
3. Close and latch the hood to complete the procedure.
7.11 Fuel Filter Change
The fuel filter should be changed
every 500 service hours, or as
needed. A plugged fuel filter can
cause loss of engine power, rough
running, or no start.
To change the filter:
1. Clean the outside of the filter
thoroughly.
2. Twist the filter element housing counter clockwise (if looking from the
bottom) and remove. Push down on the element and turn 90 degrees
counter clockwise and remove.
3. Replace with a new element and push down and turn 90 degrees
clockwise.
4. Reinstall filter element housing.
7.10-1
7.11-1
70