Vertical Tabs - Printek FormsMaster 8000 Programmer's Manual

Formsmaster 8000 series
Hide thumbs Also See for FormsMaster 8000:
Table of Contents

Advertisement

Epson FX Emulation
Relative Horizontal Tab
Move the carriage position to the left or right of the current carriage position. The displacement is
specified in 120ths of an inch, and calculated as
to the current carriage position, and must fall within the left and right margins or it will be ignored. A
negative displacement (2's complement) causes a move to the left.
Example: The following escape sequence will move the carriage one inch to the right.
Escape Sequence:
Hexadecimal:
Example: The following escape sequence will move the carriage one inch to the left.
Escape Sequence:
Hexadecimal:
Set Horizontal Tab Stops
Clears all currently set horizontal tab stops, and sets new tab stops at column n1, n2, n3, etc. 1 n 255.
The tab stops must be presented in ascending order. The NUL character, or any tab stop value less
than the preceding one, terminates the sequence. The tab stops are set relative to the current character
spacing, but subsequent changes in character spacing will not affect the physical position of the tab
stops (except that the position will be rounded up to the closest character boundary). The leftmost
column is column zero.
Default tab stops are set at every eighth column, i.e. column 8, 16, 24, 32, 40, etc. The tab stops set by
ESC D will replace the default tab stops. ESC D NUL will clear all tab stops, leaving no tab stops set.
The default tab stops are restored by ESC @.
Example: The following escape sequence will set horizontal tab stops at half inch intervals, if
character spacing is currently 10 cpi.
Escape Sequence:
Hexadecimal:

Vertical Tabs

Vertical tab stops are associated with absolute physical positions, not with lines. The tab stops are set
relative to the current line spacing, but subsequent changes in line spacing will not affect the physical
position of the tab stops.
34
n
1
n
2 256
120
ESC
\
120
0
1B
5C
78
00
ESC
\
136
255
1B
5C
88
FF
ESC
D
5
10
1B
44
05
0A
inches. The new position is relative
ESC D n1 n2 ... nx NUL
15
20
25
30
0f
14
19
1E
ESC \ n1 n2
NUL
00

Advertisement

Table of Contents
loading

This manual is also suitable for:

8003

Table of Contents