Printek FormsMaster 8000 Programmer's Manual page 21

Control code:
Hexadecimal:
Select Automatic Carriage Return
Selects automatic carriage return mode. This causes the printer to automatically perform a carriage
return (CR) for each line feed (LF), vertical tab (VT), or form feed (FF) that it receives. Overrides the
"Auto CR" value in the interface setup menu.
Escape Sequence:
Hexadecimal:
Cancel Automatic Carriage Return
Cancels automatic carriage return mode. Overrides the "Auto CR" value in the interface setup menu.
Escape Sequence:
Hexadecimal:
Reset
Deletes all data on the current line and initializes the printer to the default settings for the current form.
Restores the default horizontal tab stops. Default tab stops are set at every eighth column, i.e. column
9, 17, 25, 33, 41, etc.
Resets top of form to the current position, so it is wise to be at top of form before performing this reset.
Issuing a form feed will guarantee this.
See the chapter on Printer Reset Conditions for more information.
Escape Sequence:
Hexadecimal:
BEL
07
ESC [ 2 0
1B 5B 32 30
ESC [ 2 0
1B 5B 32 30
ESC c
1B 63
ANSI X3.64 Emulation
h
68
l
6C
ESC [ 20 h
ESC [ 20 l
ESC c
15