ANSI X3.64 Emulation
Emulations
Select Software Interface n
Selects the software interface n according to the table below.
n
0
1
2
3
4
5
6
7
?
@
Overrides the "Emulation" value in the interface setup menu.
A numeric value for n may be specified in two different ways, with equivalent results: a single byte
with a value of 00 to 07 hex, or a single printable ASCII character "0" to "7" (30 to 37 hex).
If more than one emulation has been selected, ESC ESC ? will return to the previously selected
emulation. This is particularly useful when the previous emulation is unknown. Please beware that the
memory (stack) is only one level deep.
ESC ESC @ will return to the default emulation, as specified by the "Emulation" value in the interface
setup menu.
This chapter describes ANSI X3.64 emulation. If a different interface is selected, the control codes
and escape sequences described in this chapter will no longer be applicable.
Example: The following escape sequences will select Printek emulation, load form one, and then
return to the previous emulation.
Escape Sequence:
Hexadecimal:
16
Software Interface
Test (reserved for factory use)
ANSI X3.64 Emulation
Epson FX Emulation
Bar Code Mode (optional)
IBM Proprinter Emulation
DEC LA120 Emulation
TTY Emulation
Printek Emulation
Previously Selected Emulation
Default Emulation
ESC
ESC
7
1B
1B
07
ESC
L
1
ESC ESC
1B
4C
01
1B
ESC ESC n
?
1B
3F