Port Configuration Example - QTech QSW-2800 series Configuration Manual

port-scan-mode {interrupt | poll}
no port-scan-mode
rate-violation <200-2000000>
[recovery <0-86400>]
no rate-violation
port-rate-statistics interval <interval -
value>
3. Virtual cable test
Command
virtual-cable-test interface ethernet
<interface-list>
Switch 1/
1 7
1/1
2
Switch
3
No VLAN has been configured in the switches, default VLAN1 is used.
Switch
Switch1
+7(495) 797-3311 www.qtech.ru
Москва, Новозаводская ул., 18, стр. 1
broadcast storm control function.
Configure port-scan-mode as interrupt or poll
mode, the no command restores the default
port-scan-mode.
Set the max packet reception rate of a port. If
the rate of the received packet violates the
packet reception rate, shut down this port and
configure the recovery time, the default is 300s.
The no command will disable the rate-violation
function of a port.
Global Mode
Configure the interval of port-rate-statistics.
Admin Mode
Test virtual cables of the port.

4.3 Port Configuration Example

1/
9
1/ Switch
8 2
Port Configuration Example
Port
1/7 Ingress bandwidth limit: 50 M
Explanation
1/10
Property
47