Router Configuration Overview - Alcatel-Lucent 7210 SAS T Configuration Manual

Router Configuration Overview

Router Configuration Overview
In a 7210 SAS, an interface is a logical named entity. An interface is created by specifying an
interface name under the
context where objects like static routes are defined. An IP interface name can be up to 32
alphanumeric characters long, must start with a letter, and is case-sensitive; for example, the
interface name "1.1.1.1" is not allowed, but "int-1.1.1.1" is allowed.
To create an interface on an Alcatel-Lucent 7210 SAS router, the basic configuration tasks that
must be performed are:
•
•
•
•
•
A system interface and network interface should be configured.
System Interface
The system interface is associated with the network entity (such as a specific 7210 SAS M, X), not
a specific interface. The system interface is also referred to as the loopback address. The system
interface is associated during the configuration of the following entities:
•
•
•
The system interface is used to preserve connectivity (when routing reconvergence is possible)
when an interface fails or is removed. The system interface is used as the router identifier. A
system interface must have an IP address with a 32-bit subnet mask.
Network Interface
A network interface can be configured on a physical port or LAG:
•
Page 40
Guide
configure>router
Assign a name to the interface.
Associate an IP address with the interface.
Associate the interface with a network interface or the system interface.
Associate the interface with a system or a loopback interface.
Configure appropriate routing protocols.
The termination point of service tunnels
The hops when configuring MPLS paths and LSPs
The addresses on a target router for BGP and LDP peering.
A physical or logical port
7210 SAS M, T, X, R6, R12, Mxp OS Router Configuration
context. This is the global router configuration