Router Advertisement - Alcatel-Lucent 7210 SAS T Configuration Manual

Router Advertisement

To configure the router to originate router advertisement messages on an interface, the interface
must be configured under the router-advertisement context and be enabled (no shutdown). All
other router advertisement configuration parameters are optional.
Use the following CLI syntax to enable router advertisement and configure router advertisement
parameters:
CLI Syntax: config>router# router-advertisement
interface ip-int-name
current-hop-limit number
managed-configuration
max-advertisement-interval seconds
min-advertisement-interval seconds
mtu mtu-bytes
other-stateful-configuration
prefix ipv6-prefix/prefix-length
reachable-time milli-seconds
retransmit-time milli-seconds
router-lifetime seconds
no shutdown
use-virtual-mac
The following displays a router advertisement configuration example.
*A:sim131>config>router>router-advert# info
----------------------------------------------
interface "n1"
exit
----------------------------------------------
*A:sim131>config>router>router-advert# interface n1
*A:sim131>config>router>router-advert>if# prefix 3::/64
*A:sim131>config>router>router-advert>if>prefix# info detail
----------------------------------------------
autonomous
on-link
preferred-lifetime 604800
valid-lifetime 2592000
----------------------------------------------
*A:tahi>config>router>router-advert>if>prefix#
7210 SAS M, T, X, R6, R12, Mxp OS Router Configuration Guide
autonomous
on-link
preferred-lifetime {seconds | infinite}
valid-lifetime {seconds | infinite}
prefix 3::/64
exit
use-virtual-mac
no shutdown
IP Router Configuration
Page 47