Perform The Measurement - UMS Hyprop User Manual

Perform a measuring campaign

6.6 Perform the measurement

6.6.1 Single unit mode and multiplex device mode
In general there are two modes, the single unit mode and the
multiplex devices mode. The following table shows the differences.
Sensor unit
Symbol
Weighing
Measuring time
6.6.2 Start of a measuring campaign
6.6.3 Constant starting conditions
When you set the start line there must be constant starting
conditions. This means that the tension values are constantly
horizontal for a certain time period (preparation of the sample and
hardware see chapter 6.1 ).
Single unit mode
1
remains on the scale
continuously
the selected
measuring time is
also the weighing
interval
Click the button „Start Campaign" to start the
measuring campaign. The intervals entered in
the configuration are assumed.
56/92
Multiplex device
mode
2-20
you are asked to
place each unit on
the scale according
to the measuring
cycle
you set the time
separately