Connect Sensor Units - UMS Hyprop User Manual

Hide thumbs Also See for Hyprop:

Table of Contents

Set-up the HYPROP

5.1.1

.1.1

Connect sensor units

Fig. 38: HYPROP assembly

Finally connect the main power supply unit to the plug of the last T-

piece plug and the USB converter to a free USB port on your PC.

The internal power supply of the USB-converter is capable of

powering a single sensor unit. As soon as 2 or more sensor units are

connected the USB-power supply is not sufficient. Therefore, the

main power supply unit should always be connected.

In the single device mode the HYPROP assembly remains on the

scale and the USB-cable is connected all the time. Therefore, it is

important to stabilize the USB-cable. A proper stabilization for the

USB-cable is required. Even smallest movements of the cable can

cause erroneous measurements.

The adapter cable has a 4- and a 8-pin

plug. Connect the 8-pin plug with the USB-

converter.

To the 4-pin plug connect as many T-piece

plugs as required in a row.

Now connect each sensor unit to a T-piece

plug with a sensor unit connecting cable.

Sensor units can be connected in any order

as the software recognizes the position of

any sensor unit automatically.

37/92

Table of Contents