Storing, Printing, And Data Transfer - Unitest Telaris 0751 Instruction Manual

Storing, Printing and Data Transfer
7.0 Storing, Printing
and Data Transfer
After every completed measurement, the user has
the possibility to save the measurement result by
pressing the key "Store" (10). Altogether, 600 indi-
vidual measurement results (deducting the entered
UUT numbers) may be saved. This equals approxi-
mately 150 appliance measurements.
After the saving process, it is possible to view the
last saved measurement result and to print a report
containing the measurement results using the pro-
tocol printer (option Cat. No. 1196).
If desired, the data may be transferred via a serial
interface to a PC for the reporting using the software
es control 0701/0702 (option Cat. No. 1252).
7.1 Entering the UUT Number
The key " NEW TEST"(8) is used to create a new UUT
number. All following measurements are assigned
to the new UUT. Every UUT number occupies also
one memory location.
Briefly pressing the key "NEW TEST" (8) dis-
plays the current UUT number. This number is
set to 001 after having deleted the memory or
at appliances.
When pressing the key " NEW TEST" (8) for a
longer time, a new UUT is created. The UUT
number is increased by one( 002, 003...).
If no measurement data has been saved since
the last UUT number entry, the entry of a new
UUT number is ignored. No new UUT number
will be created. It is impossible to save two sub-
sequent UUT numbers without having per-
formed any tests.
50
7.2 Saving Measurement Data
To save the measurement data, please proceed as
follows:
Perform a measurement.
Store the measurement result by pressing the
key "Store" (10). This is also possible during
active measurement, whereby the measure-
ment will not be interrupted.
After successful saving, a brief signal is audi-
ble and the symbol "M" (28) is displayed, fol-
lowed by the brief display of the continuous
memory location number.
If the memory is full and the key "Store" (10) is
pressed, the symbol "M" (10) is briefly displayed and
an error signal is audible.
The saved data is kept in the memory even
when the appliance is switched off.
It is not possible to save a measurement value
twice!
Under certain unfavourable conditions, data
may be lost or modified with any electronic
memory. The company CH. BEHA GmbH will
not be held responsible, neither for financial
nor for any other losses caused by data loss,
incorrect handling, or any other reason.
We highly recommend to perform a daily
measurement data transfer to a PC and to
save the data. The measurement data with-
in the measurement appliance might be lost
by unforeseeable and exterior influences
(drop, electro-magnetic influence, etc.).