Console Port; Ethernet Ports - Aruba AP-344 Installation Manual

Figure 3 External Antenna Connectors
External antennas for this device must be installed by an Aruba Certified Mobility Professional (ACMP) or other
Aruba-certified technician, using manufacturer-approved antennas only.
The Equivalent Isotropically Radiated Power (EIRP) levels for all external antenna devices must not exceed the
regulatory limit set by the host country/domain.
Installers are required to record the antenna gain for this device in the system management software.
!
Les antennes externes pour cet appareil doivent être installées par un professionnel de la mobilité certifié Aruba
(ACMP) ou un autre technicien certifié Aruba, en utilisant uniquement des antennes approuvées par le fabricant.
Les niveaux équivalents de puissance à rayonnement isotrope (EIRP) pour tous les périphériques d'antenne
externe ne doivent pas dépasser la limite réglementaire définie par le pays hôte / domaine.
Les installateurs doivent enregistrer le gain d'antenne pour cet appareil dans le logiciel de gestion du système.
Bluetooth Low Energy Radios
Aruba 340 Series access points are equipped with an integrated BLE radio that provide the following
capabilities:
location beacon applications
wireless console access

Console Port

The 5-pin Micro-B connector located on the back of this device. Use an AP-CBL-SERU cable for direct
management of this device when connected to a laptop or serial console. For pin-out details, refer to
Figure 4.
Figure 4

Ethernet Ports

Aruba 340 Series access points are equipped with two active Ethernet ports:
4
ANT0
ANT3
Micro-B Port Pin-out
ANT1
ANT2
1: NC
2: RX
3: TX
4: GND
5: GND
Aruba 340 Series Access Points | Installation Guide