HIKVISION DS-2CE16H5T-AIT3ZE User Manual page 7

Figure 2-6 Fix the Junction Box Cover back to its Body
9. Refer to step 6 of 2.1.1 Ceiling Mounting without
Junction Box to complete the installation.
2.2 Installation of Type II Camera
2.2.1 Ceiling Mounting without Junction Box
Before you start:
Both wall mounting and ceiling mounting are suitable
for the bullet camera. Ceiling mounting will be taken as
an example in this section. And you can take steps of
ceiling mounting as a reference for wall mounting.
Steps:
1. Paste the drill template to the place where you want
to install the camera.
2. Drill the screw holes according to the drill template
and the cable hole (optional) in the ceiling.
Note:
Drill the cable hole, when adopting the ceiling outlet
to route the cable.
3. Loosen screws to remove the clip plate, and take out
the main body.
4. Fix the mounting base on the ceiling with supplied
screws.
Figure 2-9 Fix the Mounting Base on the Ceiling
Figure 2-7 Drill Template
Clip Plate
Figure 2-8 Remove the Clip Plate