Assembly Instructions - SOLE E20 Owner's Manual

ASSEMBLY INSTRUCTIONS

1
CONSOLE MAST & CONSOLE
1. Locate the Console Mast (10) and Console Mast Cover (41) and slide the
Cover onto the Mast as far as it will go. Make sure the Console Mast Cover
(41) is facing the correct way.
2. At the top opening of the Main Frame (1) of the elliptical is a Computer Cable
(32). Unravel and straighten out the Computer Cable (32) and feed it into the
bottom of the Console Mast tube (10) and out of the top opening.
3. Install the Console Mast (10) into the receiving bracket in the top of the Main
Frame (1) Put the two Split Washers (120) and two Curved Washers (149)
onto the one Hex Head Bolt (119) and one Hex Head Bolt (121) then install
the screw at the front of the Console Mast. Put two Flat Washers (94) , two
Split Washers (120) onto the two Hex Head Bolts (119). Install and tighten by
using the 12.14m/m Wrench (111).
NOTE: There is an electrical wire running through the Console Mast Tube (10).
Be careful not to damage or pinch this Computer Cable (32) during this
procedure.
4. Install the Front Stabilizer(15) on the front stabilizer holding plate at the
bottom of the main frame with the transportation wheels facing forward and
secure them with two Carriage Bolts (148), two Curved Washers(149) and
two Cap Nuts (150) by using 12.14m/m Wrench(111).
7
Hardware Step 1
#94. 3/8" Flat
Washer (2 pcs)
#119. 3/8" x 3"
Hex Head Bolt (3 pcs)
#120. 3/8" Split Washer
(4 pcs)
#121. 3/8" x 3/4"
Hex Head Bolt (1 pc)
#148. 3/8" x 3"
Carriage Bolt (2 pcs)
#149. 3/8" Curved
Washer (4 pcs)
#150. 3/8" Cap
Nut (2 pcs)