Important Electrical Instructions - SOLE E20 Owner's Manual

IMPORTANT ELECTRICAL INSTRUCTIONS

WARNING!
• NEVER remove any cover without first disconnecting AC power supply.
• If A.C. voltage varies by ten percent (10%) or more, the performance of
your elliptical may be affected. Such conditions are not covered under
your warranty. If you suspect the voltage is low, contact your local power
company or a licensed electrician for proper testing.
• NEVER expose this elliptical to rain or moisture. This product is NOT de-
signed for use outdoors, near a pool or spa, or in any other high
humidity environment. Maximum environmental ratings are 5 to 40
degrees Celsius, and humidity is 95% non-condensing (no water drops
forming on surfaces).
IMPORTANT OPERATION INSTRUCTIONS
NEVER operate this elliptical without reading and completely understanding the results of any
operational change you request from the computer.
Understand that changes in resistance do not occur immediately. Set your desired level on the
computer console and release the adjustment key. The computer will obey the command
gradually.
NEVER use your elliptical during an electrical storm. Surges may occur in your household
power supply that could damage elliptical components.
Use caution while participating in other activities while using your elliptical such as watching
television, reading, etc. These distractions may cause you to lose balance, resulting in serious
injury.
Always hold on to a handlebar while making control changes.
TRANSPORTATION
The elliptical is equipped with transport wheels, which are engaged when the rear of the
elliptical is lifted.
EXITING DISPLAY MODE
This product is preset to a DISPLAY MODE that keeps the console continually powered on. To turn this
feature off and allow your display to go into DISPLAY MODE when not being used, please use the follow-
ing procedure:
1. When in stand-by status, hold Start, Stop and Enter keys for five seconds to enter the Engineering
Mode.
/
2. Use the keys to choose SELECT FUNCTION, then press the Enter key.
/
3. Use the keys to select the DISPLAY MODE, then press Enter key.
4. Use the / keys to turn ON or OFF the DISPLAY MODE function.
5. Hold the Stop key to save and exit Engineering Mode.
4
Plug-In