Connecting Your Resistor - National Instruments NI 4350 User Manual

Connecting Your Resistor

© National Instruments Corporation
Figure 3-9. Thermistor Measurement
See Figure 3-10 for an example of how you can use different
transducers connected to analog channels in the same measurement
setup.
You can use signal connection techniques, described in the sections,
Connecting Your RTD
as well.
The NI 4350 accessories—the CB-27T and CB-27 for the NI 4350
(PCMCIA), and the TBX-68T and TBX-68 for the NI 4350 (ISA) and
the NI 4350 (USB)—are designed to be used with RTDs, thermistors,
and resistors. Consult your accessory installation guide for instructions
on how to connect your resistors. Figure 3-10 shows an example of how
to use different transducers connected to analog channels in the same
measurement setup.
Rt
and Connecting Your Thermistor,
3-21
Chapter 3 NI 4350 Operation
IEX+
CH+
CH–
IEX–
for any resistor
NI 4350 User Manual