Configuration - National Instruments NI 4350 User Manual

Chapter 2 Installation and Configuration

Configuration

NI 4350 User Manual
Table 2-1. LED Patterns for the NI 4350 (USB) States
LED NI 4350 (USB) State
On Configured state
Off Off or in the low-power,
suspend mode
1 blink Attached state
2 blinks Addressed state
3 blinks Power supply failure
4 blinks General error state
Your NI 4350 is a completely software-configurable, Plug and Play
instrument. The Plug and Play services query the instrument and
allocate the required resources. Then the operating system enables the
instrument for operation.
Your NI 4350 (USB) is
configured.
Your NI 4350 (USB) is turned
off or in the low-power,
suspend mode.
Your NI 4350 (USB) is
recognized but not configured.
This pattern is displayed if the
host computer detects your
NI 4350 (USB) but cannot
configure it because NI-DAQ is
not properly installed or there
are no system resources
available. Check your software
installation.
This pattern is displayed if the
internal power supply shuts
down. Refer to the Power
Considerations for the
NI 4350 (USB) section for more
information.
If this pattern is displayed,
contact National Instruments.
2-4
Description
© National Instruments Corporation