Software Installation - National Instruments NI 4350 User Manual

Installation and
Configuration

Software Installation

Hardware Installation
© National Instruments Corporation
This chapter describes how to install and configure your NI 4350
instrument.
Install your software before you install your NI 4350 instrument. Refer
to the appropriate release notes for specific instructions on the software
installation sequence.
If you are using LabVIEW, LabWindows/CVI, or VirtualBench, refer
to the release notes for your software. After you have installed your
software, refer to the NI-DAQ release notes and follow the instructions
given there for your operating system and your software.
If you are using programming languages such as Visual Basic, C, or
C++ with NI-DAQ, follow the NI-DAQ instructions for installing third
party compilers.
After you have installed your software, you are ready to install your
hardware. Follow the appropriate instructions for your instrument.
♦
NI 4350 (PCMCIA)
You can install the NI 4350 (PCMCIA) in any available Type II
PCMCIA slot in your computer. Windows 95 or higher includes the
Plug and Play services your operating system will use. Windows NT 4.0
or higher includes the drivers needed to use PCMCIA cards.
The operating system configures the NI 4350 (PCMCIA) and
automatically assigns the base address and the interrupt level. Before
installing your NI 4350 (PCMCIA), consult your computer user manual
or technical reference manual for specific instructions and warnings.
2-1
Chapter
2
NI 4350 User Manual