1 Safety instructions Symbols used to mark Before using the This symbol is instructions vacuum cleaner, used to mark always read the safety instruc- operating instruc- tions that must tions and keep be observed to them readily available. prevent damage to the vacuum cleaner and its performance.
tions for safety and • Prior to changing over the appliance proper use. • If foam develops or liquid emerges Do not use any Always place the machine on a unsafe work tech- solid base during use. niques. The use of the vacuum cleaner is subject to valid national regu- CAUTION lations.
Page 7
Use only the type of power cord Make sure to install the vacuum specified in the operating man- cleaners with IP68 plug and ual. socket properly, i.e; inscrew the cap, connect the plug into the Do not damage the power cord socket, and tighten the locking (e.g.
Accessories and spare parts Use only the brushes supplied Use only original Nilfisk acces- with the vacuum cleaner or sories and spare parts (see sec- specified in the operating manu- tion 9.5). The use of other parts al. The use of other brushes can can adversely affect safety.
1. Ensure that the cleaner is 4.1.2 Electrical connection switched off. 2. Insert the power cord into a The operating voltage shown on the rating properly installed and fused plate must corres- socket with earthing contact. pond to the volt- 3.
4.2.4 Setting suction power The motor speed and the suc- tion power can be varied with the suction power control. This allows precise adaptation of the suction power for different cleaning tasks. 4.2.5 Temperature A sensor measures the exhaust haust air temperature is too high, monitoring air temperature and reduces the the suction motor is switched...
7 Maintenance Maintenance plan After finishing work As required 7.2.1 Emptying the dirt tank 7.2.2 Cleaning and replacing the filter sieve. Maintenance work 7.2.1 Emptying the dirt tank 1. Remove the upper section of cleaner from the dirt tank. 2.
Page 12
7.2.2 Cleaning and replacing 1. Switch off the cleaner and pull the filter sieve. the mains plug out of the so- cket. 2. Remove the upper section of cleaner from the dirt tank. Do not stand the upper sec- tion of cleaner on the guard. 3.
8 Troubleshooting Fault Cause Remedy ‡ Motor does not start > Fuse of the mains socket has • Connect mains fuse blown > The personal safety switch • Activate the personal safety in the mains lead of the switch. See Section 4.1.2 cleaner has been triggered „Electrical connection“...
In the event of any defect, amount of spray polish. the machine MUST be with- Technical data ATTIX 751-61 / ATTIX 751-71 / ATTIX 751-71 MWF ATTIX 19 GALLON AE CH, DK US 120 V Voltage...
Need help?
Do you have a question about the ATTIX 751-61 and is the answer not in the manual?
Questions and answers