B.42.4 Layout - Texas Instruments MSP430 User Manual

www.ti.com

B.42.4 Layout

Figure B-91. MSP-FET USB Debugger, PCB (Top)
B.42.5 LED Signals
The MSP-FET shows its operating states using two LEDs, one green and one red.
available operation modes. An
the LED is on, and an
MSP-FET not connected to PC, or MSP-FET not ready; for example, after a major firmware
update. Connect or reconnect MSP-FET to PC.
MSP-FET connected and ready
MSP-FET waiting for data transfer
Ongoing data transfer
An error has occurred; for example, target V
and cycle the power off and on. Check target connection, and reconnect MSP-FET.
Firmware update in progress. Do not disconnect MSP-FET while both LEDs are blinking.
FPGA update in progress. Do not disconnect MSP-FET while both LEDs are blinking rapidly.
SLAU278Y – May 2009 – Revised March 2016
Submit Documentation Feedback
or icon indicates that the LED is off, an
or icon indicates that the LED flashes.
Table B-46. MSP-FET LED Signals
Function
overcurrent. Unplug MSP-FET from target,
CC
Copyright © 2009–2016, Texas Instruments Incorporated
Figure B-92. MSP-FET USB Debugger, PCB (Bottom)
MSP-FET
Table B-46 lists all
or icon indicates that
Power LED Mode LED
173
Hardware