Advertisement
While the INT-IPEX1000 series extenders use Ethernet switches to distribute a
video signal to multiple displays, these devices must be installed on their own
dedicated network infrastructure.
1.
Verify all components included with the extenders are present before installation.
2.
If the extender will be sitting on a shelf, attach the supplied rubber feet to the
bottom of the product.
3.
If the extender will be secured to a surface, attach the included mounting brackets
with the supplied screws to the center screw point on the side of the extender.
Secure the extender to the surface.
4.
For a point to point installation, connect Category 5e or greater twisted pair cable
with RJ45 connectors between the extenders. TIA/EIA-568B straight-through
wiring connections are highly recommended to limit potential interference.
5.
For a video distribution installation, connect Category 5e or greater twisted pair
cable with RJ45 connectors between the extenders and Ethernet switch. TIA/
EIA-568B straight-through wiring connections are highly recommended to limit
potential interference.
6.
Connect
an
(INT-IPEX1002).
7.
Connect
an
(INT-IPEX1001).
8.
If the extenders are connected to a network switch with PoE, such as the
INT-IPSW1100 series,power supplies are not required for use. Plug the optional
power supplies (PS-5D-10) into the power input port of the extenders and lock the
power supply to the power connector by twisting the locking collar clockwise. The
red Power LED will light when receiving power.
9.
Power on attached audio/video devices.
Point-to-Point
IPEX1101
Instructions
HDMI
cable
HDMI
cable
IPEX1102
between
the
between
the
Video Distribution
IPEX1101
display
and
source
and
the
decoder
the
encoder
IPEX1102
IPEX1102
Advertisement
