Battery Recharge - Panasonic KX-TGK210HK Operating Instructions Manual

Digital cordless phone
Table of Contents

Advertisement

Useful Information

Battery recharge

Problem
The handset beeps and/or
flashes.
I fully charged the
batteries, but
still flashes or
– the operating time
seems to be shorter.
Making/answering calls, intercom
Problem
is displayed.
Noise is heard, sound cuts
in and out.
Sound quality seems to be
getting worse.
The handset does not ring. R The ringer volume is turned off. Adjust ringer volume (page 14,
I cannot make a call.
34
Cause/solution
R Battery charge is low. Fully charge the batteries (page 9).
R Clean the battery ends (
a dry cloth and charge again.
R It is time to replace the batteries (page 8).
Cause/solution
R The handset is too far from the base unit. Move closer.
R The base unit's AC adaptor is not properly connected.
Reconnect AC adaptor to the base unit.
R The handset is not registered to the base unit. Register it
(page 26).
R Activating eco mode reduces the range of the base unit in
standby mode. If required, turn eco mode off (page 13).
R You are using the handset or base unit in an area with high
electrical interference. Re-position the base unit and use the
handset away from sources of interference.
R Move closer to the base unit.
R If you use a DSL/ADSL service, we recommend connecting a
DSL/ADSL filter between the base unit and the telephone line
jack. Contact your DSL/ADSL provider for details.
R You have registered a handset that is not recommended
(page 3). The clearest sound quality is only possible by
registering the recommended handset.
20).
R Do not disturb mode is turned on. Turn it off (page 23).
R If the handset is registered to multiple base units, the handset
may not be able to make or receive calls or communicate with
the base unit when the following conditions are met.
– Base unit selection is set to "Auto" (page 21).
In this case, place the handset near the base unit, then press
MR/ECON and select "Eco" or "Eco Off". Repeat for each
base unit.
R The dialling mode may be set incorrectly. Change the setting
(page 13).
R You dialled a call restricted number (page 25).
R The key lock feature is turned on. Turn it off (page 16).
,
) and the charge contacts with

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents