Troubleshooting; Battery Recharge - Panasonic KX-TGC210C Operating Instructions Manual

Useful Information

Troubleshooting

If you still have difficulties after following the instructions in this section, disconnect the base unit's
AC adaptor, then reconnect the base unit's AC adaptor. Remove the batteries from the handset,
and then insert the batteries into the handset again.
General use
Problem
The handset does not turn on
even after installing charged
batteries.
The unit does not work.
I cannot hear a dial tone.
Menu list
Problem
The display is in a language I
cannot read.
I cannot register a handset to a
base unit.

Battery recharge

Problem
The handset beeps and/or
flashes.
For assistance, visit www.panasonic.ca/english/support
38
TGC2xxC_(en_en)_0413_ver120.pdf 38
Cause/solution
R Place the handset on the base unit or charger to turn on
the handset.
R Make sure the batteries are installed correctly (page 9).
R Fully charge the batteries (page 10).
R Check the connections (page 9).
R Unplug the base unit's AC adaptor to reset the unit.
Reconnect the adaptor and try again.
R The handset has not been registered to the base unit.
Register the handset (page 26).
R The base unit's AC adaptor or telephone line cord is not
connected. Check the connections.
R Disconnect the base unit from the telephone line and
connect the line to a known working telephone. If the
working telephone operates properly, contact our service
personnel to have the unit repaired. If the working
telephone does not operate properly, contact your service
provider/telephone company.
Cause/solution
R Change the display language (page 12).
R The maximum number of handsets (6) is already
registered to the base unit. Cancel unused handset
registrations from the base unit (page 26).
Cause/solution
R Battery charge is low. Fully charge the batteries (page 10).
2015/04/13 11:54:43