Battery Recharge - Panasonic KX-TGD390C Operating Instructions Manual

Useful Information
Problem
I cannot hear a dial tone.
Time on the unit has shifted.

Battery recharge

Problem
I fully charged the batteries, but
– still flashes,
– is displayed, or
– the operating time seems to
be shorter.
Making/answering calls, intercom
Problem
is displayed.
Noise is heard, sound cuts in
and out.
The handset does not ring.
I cannot make a call.
For assistance, visit www.panasonic.ca/english/support
30
TGD39xC_(en)_ver021.pdf 30
Cause/solution
R The base unit's AC adaptor or telephone line cord is not
connected. Check the connections.
R Incorrect time information from incoming Caller ID
changes the time. Set the time adjustment to "Manual"
(off) (page 18).
Cause/solution
R Clean the battery ends (
with a dry cloth and charge again.
R It is time to replace the batteries (page 8).
Cause/solution
R The handset is too far from the base unit. Move closer.
R The base unit's AC adaptor is not properly connected.
Reconnect AC adaptor to the base unit.
R The handset is not registered to the base unit. Register it
(page 22).
R You are using the handset or base unit in an area with
high electrical interference. Re-position the base unit and
use the handset away from sources of interference.
R Move closer to the base unit.
R If you use a DSL/ADSL service, we recommend
connecting a DSL/ADSL filter between the base unit and
the telephone line jack. Contact your DSL/ADSL provider
for details.
R The ringer volume is turned off. Adjust the ringer volume
(page 12, 18).
R Night mode is turned on. Turn it off (page 20).
R The dialing mode may be set incorrectly. Change the
setting (page 10).
, ) and the charge contacts
2016/01/25 15:56:52