Table - progeo TEKNA TILT adult User Manual

7.7

Table

This accessory can be assembled only if the wheelchair is equipped with armrests.
To insert the table, loosen the bolt A of the support S on each side of the wheelchair until the hole
is free to let the tube go through.
Insert the tubes parallel into the supports and slide the table to the desired depth.
Finally, tighten the bolt A of both support S.
Before using the table, make sure it is firmly fixed. Try to move it to-and-fro: if it does
not move, it is in condition of use.
To remove the table, loosen the bolt A of the support S on each side of the wheelchair and slide it
off.
7.8 Lumbar support
It is a pad that offers better support to
the lumbar area.
To position the lumbar support, raise the
backrest upholstery on its front side.
Via Velcro present on the parts, attach
the lumbar support either to the backrest
upholstery or to the backrest bands at
the necessary height. Finally, put the
backrest upholstery back to its normal
position.
S
A
7.9 Headrest
This accessory is designed to give support to the head.
It is suitable for folding wheelchairs; in fact, this type of headrest has a folding structure.
When you unfold the wheelchair, the headrest
unfolds, too.
When you unfold the wheelchair, the headrest
unfolds, too. To put the headrest in its using
position, pull its structure up until the two tubes A
are tilted upward starting from the central unit B.
The user or the attendant can easily adjust the position of
the headrest according to the user's need.
1
3 2
After each adjustment, screw the knob and make sure the system is stable.
Always make a check; in fact, if the system is unstable, it may be cause risky situations.
After loosening the knob of each adjustment, you can also remove the corresponding
parts.
A B A
After unscrewing the knob 1, you can adjust
the height.
After loosening the know 2, you can adjust the
depth.
After loosening the knob 3, you can adjust the
pad by turning it up/down/right/left.
Tekna Tilt 26