2
Getting Started
Up and Running overview
Getting Started
Up and Running overview
1. Make sure the wet bulb wick is clean. Fill reservoir with distilled water.
•
See "check wick and fill natural wet bulb", pg 5.
2.
Place the QUESTempº 34 & 36 in the work area in a safe location
approximately 3.5 feet off the ground.
3. Power On the QUESTempº34 & 36 and check the battery.
• If the battery voltage displayed during the power-on sequence is less than or
equal to 6.4 volts, replace or recharge the batteries.
4. Be aware that the sensors require 10 minutes to stabilize to a new
environment.
5. In the main menu, View will be selected (an indicator arrow denotes the
selected menu). Press the I/O Enter key to select.
6. Press the Run/Stop key to begin storing data.
7. Use the Up/Down Arrow keys to set the display to the desired items.
Getting started