International Harvester Company Cub Lo-Boy C-60 Service Manual page 48

4. Coat the camshaft with engine oil and
install the camshaft in the crankcase. Be
sure the camshaft gear (2) is correctly in-
dexed with the timing mark on the crank-
shaft gear (4).
8. Install the valve assemblies and
head. Refer to page 1-25.
9.
Install the oil pan.
10. Install the engine in the tractor.
Refer to page 1-11.
5. Secure the thrust plate to the crank-
case and tighten the cap screws to 20 ft. lbs.
torque. Access to each of the two screws is
through the holes in the camshaft gear.
11. Start the engine and bring up to
operating temperature.
(a) Inspect for oil leaks and check for
correct engine oil pressure.
6. Install the front cover and fan drive
pulley. Refer to page 1-39.
(b) Check and adjust the ignition timing.
7. Install the key in the rear of the
camshaft, and install the oil pump gears
and body. Install the flywheel.
(c) Check and adjust the valve clearance
if necessary. Refer to page 1-15.
1-44