International Harvester Company Cub Lo-Boy C-60 Service Manual page 18

5. Use a straight edge and inspect for
warped head, particularly in any area
which shows "blow-by."
and cause hot spots. Clean if necessary
7. Thoroughly clean the gasket surface
to insure proper sealing of the new gasket.
6. Inspect water jacket in head for an
accumulation of rust or lime deposit which
would affect circulation of cooling water
8.
Be sure to use a ~ gasket.
Installation
1. Using a new gasket, install the cyl-
inder head on the engine.
2. Install the cylinder head cap screws.
Using the sequence shoWllt tighten evenly in
steps to 45 ft. lbs. torque. Be sure to in-
stall all brackets and mounting clips under
the cap screw heads before tightening.
3. Install the spark plugs and tighten
to 30 ft. lbs. torque.
4. Install the water outlet elbow, air
cleaner, muffler, fuel tank and hood.
5.
Refill the radiator ,vith coolant.
1-14