International Harvester Company Cub Lo-Boy C-60 Service Manual page 44

3. Install the key in the crankshaft if it
was removed. Heat the crankshaft gear
and install the gear, being sure the single
timing mark of the camshaft gear and the
single mark on the crankshaft gear are
aligned.
4. Install the idler gear and shaft.
Tighten the bolt to 90 ft. lbs. torque.
The idler gear is correctly timed by lining
up the double punch mark on the idler gear
with the double punch mark on the crank-
shaft gear.
IS-tooth
(ron Kshoft
FESM-J267
~: Before installing the crankcase
front cover, mark the top surfaces of thetwo
teeth on each side of the ~~ punch
mark on the idler gear with chalk.
5. Install the crankcase front cover
with a new oil seal and gasket. Do not
tighten the cap screws at this time.
6. Install the fan drive pulley on the
crankshaft. Install the cap screw and
tighten to 80ft. lbs. torque.
7. Tighten the crankcase front cover
cap screws to 20 ft. Ibs. torque.
~: Before installing the governor
assembly, mark the front surface of the
ignition drive gear having a single punch
mark with chalk.
8. Install the governor assembly with a
new housing gasket. Time the ignition
drive gear as follows:
With the engine on top dead center of
number 1 firing stroke, mesh the marked
tooth of the ignition drive gear with the two
chalk marked teeth on the idler gear.
1-40