Allen Organ Company Quantum User Manual page 37

Make sure the word USER is selected as the mode and that GEN MIDI has been selected
following the word DISPLAY. You must advance to the next window function then press a piston
to view the sound names for any General MIDI device. The next window will display:
As you press a General or Divisional Piston, the Console Controller™ window will now display
the General MIDI sound name that corresponds to the MIDI program change selected. For
example, press General Piston 1. The Console Controller™ will display the MIDI program change
names.
Note: In some cases, the General MIDI sound name will be abbreviated in the Console Controller
window.
PROGRAM NUMBERS:
With NUMBERS selected as the display mode, the 'MIDI PROG CHANGE' window function will
display:
With PRESET selected as the program change mode, press a General or Divisional Piston. The
Console Controller™ window will display the same MIDI program change number as the
associated piston pressed. For example, pressing General Piston 1 will display:
The MIDI program change number will be displayed in PRESET mode, no matter if NUMBERS
or GEN MIDI is displayed. You must select USER mode to view the GENERAL MIDI sound
names. You must also select USER mode to assign MIDI program change numbers larger than 10
(the largest number of any piston).
With USER selected as the program change mode, along with NUMBERS as the display mode,
you will be able to assign "- - -" (OFF) or any program change number from 1 through 128 to any
General or Divisional Piston.
There may be a number or "- - -" following the "P:". This "P:" represents the Program Change
Number and does not stand for PRESET in this window. If there is "- - -" following "P:", this
means that the "ZERO" Program Change Number will be sent from the associated piston.
MIDI PROG CHANGE
GEN 1 BANK
P:Ac Grand Piano
GEN 1 BANK
P:XXX
GEN 1 BANK
P: 1
Software Version 3.02x
0
0
0
36