Allen Organ Company Quantum User Manual page 32

The ADVANCED STEPPER's position remains unchanged in memory. Pressing the "+" or "-"
pistons resumes ADVANCED STEPPER mode continuing where it left off and removes the
asterisk. Note: Manual piston presses use the memory level shown in the window.
SELECTING THE CUSTOM SEQUENCE MODE
To select the CUSTOM SEQUENCE mode, advance to the 'PISTON SEQUENCER' window
function. Use the "▲" or "▼" buttons in the Console Controller™ to select the CUSTOM
SEQUENCE mode. The display will show the number of custom piston sequences saved in
memory (XX):
To activate the CUSTOM SEQUENCE mode, return to the Main window function (see Section A-
2). The display will return to the Main window and display Custom Sequence information shown
below.
The first line displays the programmed selected capture memory level and piston combination for
the sequence with the step position shown on the second line. The stop registration will not
appear on the stopboard until a "+" or "-" piston is pressed. If there are no Custom Sequences in
memory, returning to the Main window function disables the Piston Sequencer (OFF).
A Manual piston press suspends the Custom SEQUENCE mode as indicated by an asterisk placed
aside of the "last piston pressed" field.
The CUSTOM SEQUENCE mode position remains unchanged in memory. Pressing the "+" or "-
" pistons resumes CUSTOM SEQUENCE mode and continues where it left off also removing the
asterisk.
Note: Manual piston presses use the memory level shown in the window.
SELECTING A SEQUENCE NUMBER / STEP POSITION
The CUSTOM SEQUENCE mode's position can be adjusted at any time. The "◄" or "►"
buttons in the Console Controller™ will move the cursor to either the SEQ or STEP fields. The
"▲" and "▼" buttons adjust the value in each field.
PISTON SEQUENCER
CUSTOM SEQS = XX
MEM: 1 Gen
SEQ XX STEP 1
MEM: 1 Gt
SEQ XX STEP 1
MEM: 1 Gen
SEQ XX STEP 1
Software Version 3.02x
1
1*
1
31