Allen Organ Company Quantum User Manual page 27

To set a Crescendo B sequence, use the "▲" or "▼" in the Console Controller™ to select step 1.
Adjust the stops to a suitable registration for step 1. (Note: You can play the organ at any time to
hear your selected registration) Then press and hold the SET piston. While holding SET press
the MEMORY button in the Console Controller™. The display will briefly flash the word
"DONE!!" on the first line. Release both the SET piston and MEMORY button. Step 1 is now
programmed. Repeat the above procedure to set all available step positions.
CAUTION: DO NOT USE THE CRESCENDO SHOE TO MOVE BETWEEN STEPS WHILE
PROGRAMMING CRESCENDO B STEP POSITIONS. Crescendo B data in other step positions
will cause the current stop registration on the stopboard to change, i.e. a blank step position would
turn all stops off or another subsequent step position with data (not yet re-programmed) will
change the current stop registration on the stopboard. When programming Crescendo steps
always use the "▲" or "▼" buttons in the Console Controller™ to move between steps.
To copy the current Crescendo step's stop registration to another step, use the "▲" or "▼" buttons
on the Console Controller™ to select a different step. Press and hold the SET piston. While
holding SET press the MEMORY button in the Console Controller™. The display will briefly
flash the word "DONE!!" on the first line. Release both the SET piston and MEMORY button.
The previous step has now been copied to the step position indicated in the display.
EDITING A CRESCENDO B SEQUENCE
Advance to the window function "SET CRESC B AND TUTTI B". Enter "SHOW" mode by
pressing either "◄" or "►" in the Console Controller™. The display will change to indicate
which mode is activated. Press either the "▲" or "▼" buttons in the Console Controller™ or
depress the Crescendo Shoe to activate the "SHOW" mode. The display will indicate which step
is currently activated. Use the "▲" or "▼" in the Console Controller™ to move through the step
positions one by one while observing the stops/controls. The stops/controls will change
accordingly as to which step position is currently active.
To make a change to a step position you must re-enter the "SET" mode by pressing the "◄" or
"►" buttons in the Console Controller™. The display will indicate which mode is active. The
step position counter will remain at the current step position that was selected in "SHOW mode.
Adjust the stop registration for that step. CAUTION: DO NOT MOVE THE CRESCENDO
SHOE AT THIS TIME. Once changes to the registration are complete, save the step by pressing
and holding the SET piston. While holding SET press the MEMORY button in the Console
Controller™. The display will briefly flash the word "DONE!!" on the first line. Release both the
SET piston and MEMORY button. The step is now saved to the step position indicated in the
display. To continue viewing steps you must return to "SHOW" mode by pressing either "◄" or
"►" in the Console Controller™.
SHORTCUT: While in "SET" mode you can view the Crescendo B sequence without having to
enter the "SHOW" mode by using the Crescendo shoe. However, it is important that all
Crescendo step positions be programmed before doing this. By depressing the Crescendo shoe,
the stops/controls will move accordingly as to the step displayed. You may play the organ while
doing this to hear the Crescendo sequence.
Software Version 3.02x 26