Advertisement
A12
Error Message
A42
Power Configuration (PE/NPE)
A43
Pairing
A44
Countdown Timer (Speed Sensor)
9. The Process Status indicator(s) on the console display shows "– – –" while the Pairing operation continues.
If Pairing is completed satisfactorily, the console display shows PASS.
The circuit board inside the Power Sensor cover has 2 color LEDs — 1 green and 1 red. The 2 LEDs come on during
the Pairing operation. While the operation continues satisfactorily, the green LED is on. When Pairing is completed
satisfactorily, both LEDs turn off. If the Pairing operation is not completed satisfactorily, only the red LED stays on.
If the Pairing operation is not completed satisfactorily, the console display shows FAIL. Push the pairing button on the
console (L1). Then do the Device Pairing procedure again.
10. When the Pairing procedure is completed, push the Backlight button to go back to the Service Menu.
If the Pairing operation was not completed satisfactorily, the console display shows the P– – menu option again. Push the
pairing button on the console (L1). Then do the Device Pairing procedure again.
11. Tap the STAGE or AVG/END button until you see the "– – –" (exit) option in the Service Menu, and push the Backlight button.
12. Install the console and sensors on the bike. Refer to the MPower™ installation guides.
Device Pairing for Multiple Bikes
For Schwinn A.C.™ bikes with MPower™ Consoles in a group setting, make sure to set up Device Pairing for only one bike at a time
to prevent crosstalk between the devices on different bikes.
NOTICE: When you remove the handlebars (with console) to clean them, make sure that you install them again on the
same bike to keep the Device Pairing correct. If you install the handlebars and console on a different bike, the
console does not read data from the correct sensors.
Recommendation: You can put number labels on the bikes and handlebars to make sure that the Device Pairing stays
The Service Mode menu lets Service Technicians set the bike configurations, see maintenance data, do calibrations and upgrade
the console firmware. Access to Service Mode is available when the console is in User Setup Mode:
• • •
Push the STAGE and AVG/END buttons for 5 seconds to go to Service Mode.
• • •
Tap the AVG/END or STAGE button to look at the Service Mode menu options.
• • •
Push the Backlight button to make your selection and go to the submenu options.
• • •
Tap the AVG/END or STAGE button to look at the submenu options.
• • •
Push the Backlight button to set the correct option.
• • •
The console goes back to the Service Mode menu and the current menu option appears.
Note:
If the Exit option does not let you out of the Service Menu option, there is possibly a Pairing problem with the
console or one of the sensors.
correct.
Configuration / Service Mode
A45
Process Status (Speed Sensor)
A46
Process Status (Power Sensor)
A47
Countdown Timer (Power Sensor)
A48
Pairing Indicator
13 13 13
Advertisement
