Advertisement
Ant+
Watch
For bikes that do not have a Power Sensor installed, user weight data is necessary to calculate the Calories during the workout. If
the console does not get the weight data from a device, you must manually set the weight value. The + and – icons on the LCD flash,
and the RPM field displays 170 lbs. (80 kg). Use the STAGE (–) and AVG/END (+) buttons to adjust the number to your weight.
Note: To change the weight units to English Imperial or metric:
• • •
• • •
• • •
• • •
• • •
Push the Backlight button to record your weight.
During User Setup (while RPM is less than 80), it is possible to lose the proximity linking to an Ant+ watch or Ant+ HRM if you move
too far away from the Console. If this occurs for the Ant+ watch, the Ant+ watch indicator flashes. If this occurs for the Ant+ HRM,
the HR display field shows 0 (zero). You must do the proximity linking procedure again.
If Workout Mode does not start in 45 seconds, there is no keypad activity and RPM is less than 5, the console returns to Sleep Mode.
Workout Mode
After User Setup is complete, start pedaling the bike. When the Cadence RPM increases to 80 RPM or more, the console goes into
Workout Mode. The Workout STAGE and TOTAL icons come on and the workout measurements start.
Push the STAGE and AVG/END buttons for 5 seconds to go to Service Mode.
Tap the AVG/END button until you see the UN menu option, and push the Backlight button.
Push the STAGE or AVG/END button to see the UN menu options—UN0 (metric) and UN1
(Imperial). Push the Backlight button to set the units measure.
The console goes back to the Service Mode menu and the UN menu option appears. Tap the
STAGE or AVG/END button until you see the "– –" (exit) option in the Service Menu.
Push the Backlight button to go back to User Setup Mode.
HRM
10 10 10
Advertisement
