Advertisement
Condition/Problem
Console does not come on
Speed display is not accurate
No Speed display
No Power display
No Heart Rate display while using chest
strap
Note: The LCD display is different for Errors that occur during Service Mode and Errors during non-Service
Mode.
Error
Code
E00
Console did not pair with Speed Sensor correctly. (This
error only occurs after Device Pairing was not completed
satisfactorily.)
E01
Console did not pair with Power Sensor correctly. (This
error only occurs after Device Pairing was not completed
satisfactorily.)
E02
Power Sensor did not pair with Speed Sensor correctly.
(This error only occurs after Device Pairing was not
completed satisfactorily.)
Troubleshooting
No batteries or dead batteries
Display set to wrong unit of measure.
(English/Metric)
Speed sensor
Power sensor
Transmitter contact with skin
Electromagnetic interference
Chest strap transmitter
HR receiver
Condition/Problem
Check
Replace batteries.
Go to Service Mode menu and change
the Units configuration.
Make sure Speed Sensor is installed.
Replace Speed Sensor battery.
Make sure Power Sensor is installed.
Replace Power Sensor battery.
Moisten skin contact area on the chest
strap.
Turn off any television, AM radio,
microwave, or computer within 6 feet (2
meters) of the bike.
Test chest strap with another HRM
device such as HR watch or a machine
at a gym. If transmitter has good skin
contact and still does not send a HR
signal, replace chest strap transmitter.
If chest strap is known to work with other
devices and no sources of interference
are present, or console is tested with a
Pulse Simulator and does not receive the
signal, contact Nautilus Customer Care.
Push the pairing button on the back of the Console,
Speed Sensor and Power Sensor (if applicable) and try
the Device Pairing procedure again.
Replace all batteries, and try the Device Pairing
procedure again.
Push the pairing button on the back of the Console,
Speed Sensor and Power Sensor (if applicable) and try
the Device Pairing procedure again.
Replace all batteries, and try the Device Pairing
procedure again.
Push the pairing button on the back of the Console,
Speed Sensor and Power Sensor (if applicable) and try
the Device Pairing procedure again.
Replace all batteries, and try the Device Pairing
procedure again.
26 26 26
Solution
Solution
Advertisement
