Advertisement
Power
Sensor
2. Push the STAGE and AVG/END buttons for 5 seconds to go to Service Mode.
3. Tap the AVG/END button until you see the P– – menu option, and push the Backlight button.
4. Push the STAGE or AVG/END button to see the P– – submenu options—PE0 (not power enabled) and PE1 (power enabled).
• • •
If you have a Power Sensor, go to the PE1 option and push the Backlight button to set PE (power enabled).
• • •
If there is no Power Sensor, go to the PE0 option and push the Backlight button to set NPE (not power enabled).
5. The console goes back to the Service Mode menu and the P– – menu option appears.
6. Make sure that the switch (U) on the Speed Sensor is set to S (speed).
7. Push the pairing buttons on the Console (L1), the Speed Sensor (L2) and the Power Sensor (L3), if applicable.
8. The console display shows PPP and the time display counts down from 0:35 (seconds).
12 12 12
Advertisement
