Figure 70. Rf Cable Connection Using Jma Boots (1); Table 26. Parts And Tools For Connecting Rf Cable - Samsung RFD01F series Installation Manual

1

Table 26. Parts and Tools for connecting RF cable

Category Description
Installation RRU ANT0, ANT1, ANT2, ANT3 ~RF Antenna
Section
Cable RF Cable Assembly (1/2 in. Feeder Line)
Connector RRU
RF antenna
Recommended RRU
Torque Value
RF antenna
Working Tools
Torque Wrench(100~400 lbf·in), Spanner Head(Hexagon Head: 1.25 in.(32 mm)),
Spanner(Hexagon: 1.25 in.(32 mm))
2

Figure 70. RF Cable Connection using JMA Boots (1)

[RF Antenna]
3
RFD01F Series Installation Manual v1.0
© Samsung Proprietary and Confidential
To connect RF cable using JMA Boots
Make sure that operator has the following items:
Install RF cable assembly from the RRU ANT0, ANT1, ANT2, ANT3 ports to
the RF antenna. (There are JMA boots on both sides of the RF cable assembly.)
RF Cable Assembly
Connect the connector assembled at the end of RRU side's cable to the
ANT_0, ANT_1, ANT_2, ANT_3 ports.
DIN Type-Male, Straight
DIN Type-Male (Check the RF antenna specification and
prepare connecting parts.)
217 lbf·in
217 lbf·in
Chapter 3 Connecting Cables
[Bottom View]
76