Precor ELLIPTICAL FITNESS CROSSTRAINERS EFX 835 Assembling And Maintaining Manual page 26

24
2. To attach the upper body handlebars, place one split
3. Attach the handlebars to the link arms using two hex
4. Fully tighten the fasteners using a ⁹₁₆-inch box-end
5. Align the cut-out inside the link arm cap with the link arm
Assembling and Maintaining Elliptical Fitness Crosstrainers: EFX 885 / 835
washer and one ⁵₁₆-inch washer on each of six
socket-head cap screws, then insert three of the screws
through each handlebar bracket. Fully tighten the
fasteners using a ¼-inch hex key.
Figure 16: Upper body handlebar attachment detail
Important: In the following step, install the fasteners in the
order presented. The bushing slides inside the link arm. The
heads of the screws remain on the ramp side of the link arm.
head screws, two bushings, and four ³₈-inch washers.
Note: For ease of installation, slide the corresponding foot
pedal to the top of the ramp before attaching each
handlebar.
wrench.
Figure 17: Link arm attachment
mounting hole. Apply pressure to the cap until it snaps
into place.