Nylon Line Installation; Support Handle - Echo GT-225 Operator's Manual

GT-225

Nylon Line Installation

1. Shut engine OFF. Lay unit on
the ground with head assembly
up.
2. Remove old nylon line through
center recess of head.
3. Thread new lines through
outside holes (A) in housing
until ends meet in center of
recess.
Note: Insert cutting line ends to
center of head recess to
insure easy removal of
used lines.

Support Handle

Note: Label (A) shows
minimum spacing for
Support Handle
location.
Note: Support Handle is pre-
installed. Re-
positioning and tightening is all that is required.
1. Position Support Handle (A) in
comfortable operating position
and tighten wing nut (B). The
cutting attachment should be
5 cm to 7.5 cm (2 in. to 3 in.)
above the ground and as level
as possible.
X7732273900
© 10/2017 ECHO Inc.
ASSEMBLY
A
A
A
B
A
17