ASSEMBLY
ASSEMBLY
Shield Installation
(Nylon line operation)
Parts required: Debris Shield, Shield Plate, three 5 x 16 mm screws.
This unit cannot be converted for brushcutter use.
1. Place shield (A) on the bottom of the bearing housing
flange.
2. Place shield plate (B) on shield, align holes. Install three
screws from bottom through plate and shield into gear case.
3. Assemble adapter plate (C) onto PTO shaft.
Nylon Line Head Installation
Parts required: Nylon Line Head.
Wear Gloves or personal injury may result:
• Cutoff knife is sharp.
• Gearcase and surrounding area may be hot.
1. Be sure adapter plate (A) remains on PTO shaft (B).
2. Align locking hole in upper plate with notch in edge of gear
housing and insert head locking tool (C).
12
C
A
B
C
© 01/22 ECHO Incorporated
SRM-225
A
B
X7732278503