Spark Plug; Cooling System - Echo GT-225 Operator's Manual

GT-225
Note: Federal EPA regulations require all model year 2012 and later
gasoline powered engines produced for sale in the United
States to be equipped with a special low permeation fuel
supply hose between the carburetor and fuel tank. When
servicing model year 2012 and later equipment, only fuel
supply hoses certified by EPA can be used to replace the
original equipment supply hose. Fines up to $37,500.00 may
be enforced for using an non-certified replacement part.

Spark Plug

Level 2.
Parts Required:
Use only NGK BPM8Y spark plug (BPMR8Y in Canada) otherwise
severe engine damage may occur.
1. Remove spark plug and check
for fouling, worn and rounded
center electrode.
2. Clean the plug or replace with a
new one. DO NOT sand blast to
clean. Remaining sand will
damage engine.
3. Adjust spark plug gap by
bending outer electrode.
4. Tighten spark plug to 150 - 170 kgf•cm (130 - 150 in•lbf).

Cooling System

Level 2.
To maintain proper engine operating temperatures, cooling air must
pass freely through the cylinder fin area. This flow of air carries
combustion heat away from the engine.
X7732273900
© 10/2017 ECHO Inc.
Tune-Up Kit
MAINTENANCE
0.65 mm (0.026 in.)
27