Table of Contents
Advertisement
GT-225I
1.
Remove wing nut (A), washer
(B), and bolt (C).
2.
Snap the shield over the
bearing housing.
3.
Install bolt (C), washer (B), and
wing nut (A).
Nylon Line Installation
1.
Shut engine OFF. Lay unit on
the ground with head assembly
up.
2.
Remove old nylon line through
center recess of head.
3.
Thread new lines through
outside holes (A) in housing
until ends meet in center of
recess.
Note: Insert cutting line ends to
center of head recess to
insure easy removal of
used lines.
Support Handle
Note: Label (A) shows
minimum spacing for
Support Handle
location.
Note: Support Handle is pre-
installed. Re-
positioning and tightening is all that is required.
X7732274600
© 10/2017 ECHO Inc.
ASSEMBLY
B
A
A
A
A
C
17
Advertisement
Table of Contents
