Resetting Latched Events; Inhibiting Channels; To Inhibit Input Channels; To Clear Inhibits - Honeywell Touchpoint Plus User Manual

4.9.3 Resetting Latched Events

Note: Password access is required.
Acknowledged latched events can be reset in three ways:
1) By logging in and pressing the
provided that the event has cleared. It will also reset any latched relay outputs.
2) By logging in and selecting
provided that the input signal has returned to Normal / within tolerance.
3) By holding the Remote reset switch for >3 seconds. TPPL has the option of adding a remote acknowledge / reset
switch up to 500 m away from the Controller. The remote reset switch does not require a login so a key-lockable
switch should be used to prevent unauthorised access.

4.10 Inhibiting Channels

Note: Service or higher access level is required.

4.10.1 To Inhibit Input Channels:

1) Log in as Administrator or Service
2) Touch a channel, then touch the inhibit icon:
3) Or use a Remote Inhibit input (key-locking) switch.

4.10.2 To Clear Inhibits:

1) Log in as Administrator or Service
2) Touch an inhibited channel, then touch the inhibit icon:
Note: An auto-inhibit cannot be cleared manually. Auto-inhibits may occur during calibration or warm-up, when a
transmitter is signalling Inhibit, or when an Inhibit delay time is running.

4.10.3 To Change Inhibit Timeouts

1) Log in as Administrator or Service
2) Touch a channel, then touch the Settings icon:
3) Touch [Next] repeatedly until you reach page 7/7, as shown below:
4) Touch the chosen value, enter a new value, and touch [Finish]>[Finish]>[Apply]
Please see Ch12. Icon Glossary for further information.
MAN0996_Iss 1_02/16
Pt. No. 3011M5044_EN
Daily Operation
button for >3 seconds. This will reset ALL latched alarms, faults and warnings,
Menu>Maintenance>Reset Alarms/Faults
and then touch [Yes]
34
. This will reset all latched events,
and then touch [Yes]
Touchpoint Plus
User Guide