Table of Contents
Advertisement
Operating
7
Operating
7.1 Starting the device
7.2 Main menu
Selecting DMX mode
DMX address
16
CAUTION!
Risk of injury due to movements of the device
The head of the device can move quickly (pan, tilt) and can produce
very bright light. This is also valid immediately after you turn on the
device, when the device operates in automatic mode or under remote
control and when you turn off a DMX controller that is connected to the
device. Persons staying near the device could be injured or frightened.
Before you turn on the device and during the operation, always ensure
that nobody stays close to the device. If work has to be performed in the
area of movement or in the near vicinity of the device, it must remain
turned off.
Make sure that the transport protection is not engaged and that the head carrier is
free to move. Connect the device to the power grid and turn it on with the main
switch to start operation. After a few seconds, the fans start to work, the head moves
to the home positions for rotation (pan) and inclination (tilt), the screen displays a
start message. After a few more seconds, the device operates in the last set mode.
Press [ENTER] to activate the main menu. Use the buttons [UP] or [DOWN] to select a
submenu. When the display shows the desired submenu, press [ENTER] to open it. To
close the main menu, press [MENU]. The stored values are displayed in white in the
display. Changed values are displayed in red until they are confirmed by [ENTER] .
All previously made settings are retained even when you disconnect the device from
the power grid. To restart with default values, use the function 'System Reset' .
Press [ENTER], then [UP] or [DOWN] until the display shows 'USERS MODE' . Press
[ENTER]. With the buttons [UP] or [DOWN] you can choose between the following
DMX operating modes: 'Stand mode' (26 channels), 'Shapes' (45 channels) or
'Extended' (54 channels). This setting is only relevant when the device is controlled
via DMX.
When the display shows the desired value press [ENTER] to save the settings. Press
[MENU] to close the menu.
Press [ENTER], then [UP] or [DOWN] until the display shows 'ADDRESS' . Press [ENTER].
The display shows 'Set DMX Address' . Press [ENTER]. Now you can set the number of
the first DMX channel to be used by the device (DMX address). Use the buttons [UP]
or [DOWN] to select a value between 1 and 512.
When the display shows the desired value press [ENTER] to save the settings. Press
[MENU] to close the menu.
moving head
Advertisement
Table of Contents
