Cisco 380 Series Hardware Installation Manual page 23

Chapter
Table 1-1 Front Panel LEDs, Definitions of States (continued)
LED Name
System status
Identification
Power button/Power status LED
OL-29172-01
State
Green—The appliance is running in normal operating condition.
•
Green, blinking—The appliance is performing system initialization and memory
•
check.
Amber, steady—The appliance is in a degraded operational state. For example:
•
Power supply redundancy is lost.
–
CPUs are mismatched.
–
At least one CPU is faulty.
–
At least one DIMM is faulty.
–
At least one drive in a RAID configuration failed.
–
Amber, blinking—The appliance is in a critical fault state. For example:
•
Boot failed.
–
Fatal CPU and/or bus error is detected.
–
Appliance is in over-temperature condition.
–
Off—The Identification LED is not in use.
•
Blue—The Identification LED is activated. (For more information, see
•
Hard Drives" section on page
Off—There is no AC power to the appliance.
•
Amber—The appliance is in standby power mode.
•
Green—The appliance is in main power mode. Power is supplied to all appliance
•
components.
3-3.)
Cisco 380 and Cisco 680 Series Hardware Installation Guide
"Replacing
1-9