Cisco 380 Series Hardware Installation Manual page 34

–
–
Console port—for use with the CLI.
b.
–
–
–
Ethernet ports—direct connection.
c.
–
–
Connect the power cord to the Cisco 380 and Cisco 680 appliance and connect the other end to your
Step 4
power source.
Step 5 Power on the appliance.
If turned on quickly after connecting power to the appliance, the appliance powers up, the fans spin, and
Note
the LEDs turn on. Within 30-60 seconds, the fans stop and all LEDs turn off. The appliance powers on
31 seconds later.
This behavior is by design to allow the system firmware and controller to synchronize.
Check the Power LED on the front of the Cisco 380 and Cisco 680 appliance. When it is solid green, the
Step 6
appliance is powered on.
For additional information on installation and post-installation tasks, see the following hardware Quick
Start Guides:
Cisco M380 and M680 Content Security Management Appliance Quick Start Guide
•
Cisco M380 and Cisco M680 Content Security Management Applicance Quick Start Guide
•
Cisco S380 and Cisco S680 Web Security Applicance Quick Start Guide
•
Cisco 380 and Cisco 680 Series Hardware Installation Guide
2-8
Connect one RJ-45 connector to the management interface port.
Connect the other end of the Ethernet cable to the management port on your computer and make
sure that your computer is configured to obtain an IP address using DHCP.
Connect the console cable. The console cable has a DB-9 connector on one end for the console
port on your computer and the other end is an RJ-45 connector.
Connect the RJ-45 connector to the console port on the Cisco 380 and Cisco 680 appliance.
Connect the other end of the cable, the DB-9 connector, to the console port on your computer.
Connect the RJ-45 connector to the Ethernet port.
Connect the other end of the Ethernet cable to your network device, such as a router, switch, or
hub.
Chapter
OL-29172-01